Anchor-industries NAVI-TRAC NAV40GBL-1104 Instrukcja Użytkownika

40’ Wide Gabled End SystemQuality, Craftsmanship and Service since 1892NAV40Gbl-1104Copyright © Anchor Industries 2004Please read all assembly / insta

10ERECTING 2nd BEAM 1stSECURING THE 1st BEAM SAFELYERECTING THE 2nd BEAMWORKERS LIFT FIRST AT THEPEAK, THEN SHUFFLE SIDEWAYSTOWARD THE UPRIGHTS. AS

11SECURING THE 2nd BEAM WITHDROP-IN RIDGE/EAVE BARSINSTALLING PURLINS AND RIDGE BARSCOMPLETING THE 1ST BAYIN 20’ MID BAYS ONLY, INSTALL A SUPPORT PURL

12COMPLETING THE TOP FRAMEINSTALLING GABLED END FRAMEINSTALLING GUY WEBS BEFORE INSTALLING FABRICSTAKING DISCLAIMER: DUE TO VARYING SOIL CONDITIONS A

13INSTALLING MID PANELPULL MID PANEL UP AND OVER THROUGH CHANNELS IN RAFTER EXTRUSIONS.WHEELED PANELGUIDERAFTERINSERT FINGERS OF WHEELED PANEL GUIDE I

14COMPLETED 40’ GABLED END NAVI-TRAC WITHFABRIC INSTALLED AND TENSIONED, GUYWEBS STAKED AND RATCHETED TIGHT. TOMEET ENGINEERING REQUIREMENTS WALLSSH

15HIP/GABLED END COMBINATION UNITSEE THE STANDARD NAVI-TRACINSTALLATION INSTRUCTIONS FORASSEMBLY OF THE HIP END UNIT.EXTENSION BEAMS ARE PIVOTEDIN THE

EVANSVILLE, INDIANA28.3 11-01-02Thank you for purchasing an Anchor product. In return, we pledge Quality, Service andCraftsmanship and are available

TABLE OF CONTENTSPage No. Assembly Step3 Introduction with Frame Terminology Illustration4 Component Illustrations5 40’ Navi-Trac Component List Table

340’ Gabled Navi-Trac Frame TerminologyINTRODUCTION:Like the hip-end version, the gabled end NAVI-TRAC frame is made up of extruded aluminum members j

40’ NAVI-TRAC COMPONENT ILLUSTRATIONS4

40’ NAVI-TRAC COMPONENT LISTA MINIMUM GABLED UNIT CONSISTS OF (1) KIT #1, (1) KIT #2 AND (2) EXTENSION MIDS.TO EXTEND THE LENGTH FURTHER, SIMPLY ADD A

6I.D. 40’ GABLED END NAVI-TRACLABEL(LETTER ONDRAWING)COMPONENT DESCRIPTIONCODES(STAMPED ORTAPED)GBLKIT1GBLKIT2HIPKIT320’MIDSTR20’MIDEXT15’MIDSTR15’MID

7NAVI-TRAC INSTALLATION SAFETY GUIDELINESYour installation techniques will evolve to fit the needs of your clients, the experience level of your crews

DIRECTIONS FOR SQUARING THE TENT1. USE A TAPE MEASURE TO MARK THE ENDS OF A LINE FOR ONE END (A TO B ABOVE) EQUAL TO THE EXACT WIDTH OF THE UNIT.2.

9134265CONSTRUCT FIRST BEAMLAYOUT OF ALL BEAMSMCW RW ON MID BEAMS, RWE ON END BEAMSR21-9U8BHWT-30 XRB FOR (X-CABLED BEAMS ONLY)MAKE CONNECTIONS IN NU